Axial cylindrical roller bearings comprise axial cylindrical roller and cage assemblies K, housing locating washers GS and shaft locating washers WS. The bearings have very low axial section height, high load capacity, high rigidity and can support axial forces in one direction.

Bearings 811, 812 are single row bearings and conform to DIN 722/ISO 104, bearings 893, 894 are double row bearings and conform to DIN 616/ISO 104.

The cages are made from plastic or brass.

The cage assemblies comprise axial cages and one or two rows of cylindrical rollers. The diameter series 1, 2, 3, 4 correspond to DIN 616/ISO 104.

The cages are made from plastic or brass and are guided as standard on the shaft.

The cage assemblies have very low axial section height and high load carrying capacity. They can support axial forces in one direction. Radial forces must be supported by separate means.

Axial cage assemblies are combined with shaft or housing locating washers or are integrated directly in the adjacent construction. If they are used without axial bearing washers, the raceway must be produced as a rolling bearing raceway.

Housing locating washers are centred on the housing and must be used if the adjacent construction cannot be used as a running surface. The bore diameter, outside diameter and running surface are precision machined. The diameter series 1, 2, 3, 4 correspond to DIN 616/ISO 104.

Shaft locating washers are centred on the shaft and must be used if the adjacent construction cannot be used as a running surface. The bore diameter, outside diameter and running surface are precision machined. The diameter series 1, 2, 3, 4 correspond to DIN 616/ISO 104.

Bearing washers can be used as housing or shaft locating washers; they are used in applications where precise centring is not required. The bore and outside surface are turned, the running surface is ground.

Bearing washers can be used with axial cylindrical roller and cage assemblies K811 and axial needle roller and cage assemblies AXK.

Axial cylindrical roller bearings and axial cylindrical roller and cage assemblies can be used at operating temperatures from –20 °C to +120 °C.

Suffixes for available designs: see table.